Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Manual do Utilizador descarregar pdf (Página 15)

Remote Link II Technical Guide

Operator Interface

Prism and Prism II Setup Instructions for Alarm Call-Outs

Prism Setup for Alarm Call-Outs

1. Open your Prism software. Click on the

<Key> button and type in your level 3

passcode (default “sm”). Click <Done>.

2. If Prism is ofﬂ ine, click

<Communications> and

then click <Go Online>.

3. Click

<Communications> and then click

<Setup CommLink>.

4. The CommLink Setup Window will appear. Click

<Load Settings>. Type in the number of the

receiving cell phone in the pager ﬁ eld.

Click

<Save Settings> and then click <Done>.

5. In your cell phone entries, create an entry for each of

your job sites with its corresponding phone number so

that you know which job site has an alarm.

Prism II Setup for Alarm Call-Outs

1. Open your Prism II software. Click on the

<Keys> button and type in your level 3

passcode (default “9288”). Click <OK>.

2. Click

<Communications> and then click

<Setup CommLink>.

3. The CommLink Settings Window will appear. Click

<Load>. Type in the number of the receiving cell

phone in the cell/pager ﬁ eld. Click <Save> and

then click

<Exit>.

4. In your cell phone entries, create an entry for each of

your job sites with its corresponding phone number so

that you know which job site has an alarm.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Auto-zone-control-systems Remote Link II Technical Guide, Installation Instr Manual do Utilizador Página 15